Jay.Bookout

Members
  • Content count

    3
  • Joined

  • Last visited

  1. Thanks all, I did another hub reset, rebuilt the zwave network, and will hope for the best. If not I am going to reset all the devices and reconnect. Thanks again for the insight! Sent from my iPhone using Tapatalk
  2. Only rebooted the hub. The iris tech had said next step is to remove my devices and reconnect. The premise of walking my hub around to 60 devices made me see red. I really feel whatever they pushed out has caused this, and was hoping I was not an isolated case. Have others here had the update yet and is your system functioning as normal??? Sent from my iPhone using Tapatalk
  3. So I joined this forum after browsing it for years. I was one of the holdouts to migrate from V1 to V2 and have 60+ devices. I have had no issues until the morning of 4/1. I got the new firmware update which, after calls to iris support, I have been told "only adjusted security settings on the backend and would not affect my environment at all." Well, that cannot be true. Every morning since all of my lighting, switches, and GE devices are disconnected, every single one of them. Alexa can't find the devices, scenes don't run, scheduled tasks fail, and until I go and manually trigger every device, the network is useless. Once I power or toggle the switch/plug/outlet a few times, they reconnect. I have rebuilt my zwave network twice, I have reset/rebooted the hub multiple times, and iris support is sending me a repeater plug as apparently they feel my zwave network that has been solid for 12 months has decided to become weak signaled right as they roll out the firmware. I don't know where to go from here and if I am an isolated incident. Anyone else have this issue presently or previously? Sent from my iPhone using Tapatalk