Wlepse 64 Report post Posted April 30, 2018 I recently added several new door/window switches (Gen 1) but had a lot of trouble getting them to pair. Each one took several minutes even sitting next to the hub. Some even timed out and I had to try again. Then after they were all paired I am noticing very slow response in the app to updates in state. Often 20 or more seconds to more than a minute at times. Has anyone else seen this lately? I don't recall see this in the past. I remember being able to pair and basically see the state change instantly in the app. Did they change the refresh timing or something? Share this post Link to post Share on other sites
ade194 78 Report post Posted May 3, 2018 I've noticed occasional slow response when using the app to operate lights and slower than usual history updating Share this post Link to post Share on other sites
Wlepse 64 Report post Posted May 3, 2018 I am wondering if it has something to do with local processing. There was a thread about someone noting the system was using much less bandwidth, I wonder if the hub is handling these activities and only posting changes at set intervals if they happen so the updates are a bit slow. Share this post Link to post Share on other sites